Explore projects
-
-
Program for an Arduino to control a cooling pump based on temperature and output the status to an LCD
Updated -
This is a basic configuration library for an Arduino with an SD card. I made this when I required a library that allows me to read and write the configuration to an SD card on an Arduino.
Updated -
Binary watch using an ATtiny microprocessor. Aiming to use ATtiny5 (512bytes flash, 32bytes RAM, 6 pins).
Updated -
Modding the Philips CDR 760 to make it accept non-audio CD-R and CD-RWs for recording.
Updated -
My modification of the Arduino-Websocket library by Branden Hall
Updated -
This project aims to allow quick and easy setup of an Arduino as a multi-device MQTT, allowing the Arduino to act as multiple input and/or output devices simultaneously (e.g. a light control, alarm, switches, environmental sensors, etc). See Wiki.
Updated -
Updated
-
Replacement for a thermostat.
System has two controls, boiler and pump. For hot water, boiler is enabled and hot water moves by convection to hot water tank. For heating, boiler and pump are enabled. If heating on, hot water is also on.
Check Wiki
Updated